User manual

Table 6-11 below describes miscellaneous options links.
Option Link Settings
Reference Function Fitted Alternative ( Removed ) Related
To
R37 HW Reset
Circuit
Connects the reset signal generated from
on-board reset circuit to the MCU at reset
pin (pin 9)
Disconnects the reset signal generated from
on-board reset circuit from the MCU reset pin
(pin 9)
-
R41 HW Reset
Circuit
Connects the pin 14 of E8a to GROUND
Disconnect pin 14 of E8A connector from
ground
-
R97 LIN
Connects the Board_VCC to VBAT
Disconnects the Board_VCC from VBAT -
Table 6-11: Miscellaneous Option Links
6.8. Oscillator Sources
Crystal oscillators are fitted on the board and used to supply the main/sub clock input to the Renesas microcontroller.
Table 6-12 details the oscillators that are fitted on this RSK:
Component
Crystal (X1) Fitted 20 MHz (HC49/4U package)
Crystal (X2) Not Fitted For test purpose only
Crystal (X3) Fitted 32.768 KHz (90 SMX package)
Table 6-12: Oscillators / Resonators
6.9. Reset Circuit
A reset control IC (i.e. RNA51957BFP) has been used to generate the reset signal required for the R8C/38C CPU.
Please check the hardware manual for the detailed reset requirements to ensure the reset circuit on the user’s board meets all the reset
timing requirements.
16