Datasheet

Rev. 2.00 Sep. 28, 2009 Page xxxix of xl
REJ09B0429-0200
Table 18.5 LPC I/O Cycle ...................................................................................................... 599
Table 18.6 GA20 Setting/Clearing Timing............................................................................. 605
Table 18.7 Fast Gate A20 Output Signals............................................................................... 607
Table 18.8 Scope of LPC Interface Pin Shutdown ................................................................. 609
Table 18.9 Scope of Initialization in Each LPC interface Mode............................................. 610
Table 18.10 Serialized Interrupt Transfer Cycle Frame Configuration .................................... 613
Table 18.11 Receive Complete Interrupts and Error Interrupt.................................................. 615
Table 18.12 HIRQ Setting and Clearing Conditions when LPC Channels are Used................ 617
Table 18.13 HIRQ Setting and Clearing Conditions when SCIF Channels are Used............... 618
Table 18.14 Host Address Example.......................................................................................... 620
Section 19 A/D Converter
Table 19.1 Pin Configuration.................................................................................................. 623
Table 19.2 Analog Input Channels and Corresponding ADDR Registers .............................. 625
Table 19.3 A/D Conversion Characteristics (Single Mode) ................................................... 633
Table 19.4 A/D Conversion Characteristics (Scan Mode)...................................................... 633
Table 19.5 A/D Converter Interrupt Source............................................................................ 635
Table 19.6 Standard of Analog Pins ....................................................................................... 640
Section 21 Flash Memory
Table 21.1 Comparison of Programming Modes.................................................................... 646
Table 21.2 Pin Configuration.................................................................................................. 652
Table 21.3 Register/Parameter and Target Mode ................................................................... 653
Table 21.4 Parameters and Target Modes............................................................................... 663
Table 21.5 Setting On-Board Programming Mode................................................................. 673
Table 21.6 System Clock Frequency for Automatic-Bit-Rate Adjustment by This LSI......... 675
Table 21.7 Executable MAT................................................................................................... 695
Table 21.8 (1) Useable Area for Programming in User Program Mode................................... 696
Table 21.8 (2) Useable Area for Erasure in User Program Mode............................................. 698
Table 21.8 (3) Useable Area for Programming in User Boot Mode......................................... 700
Table 21.8 (4) Useable Area for Erasure in User Boot Mode................................................... 702
Table 21.9 Hardware Protection ............................................................................................. 705
Table 21.10 Software Protection............................................................................................... 706
Table 21.11 Inquiry and Selection Commands......................................................................... 714
Table 21.12 Programming/Erasing Command.......................................................................... 727
Table 21.13 Status Code ........................................................................................................... 736
Table 21.14 Error Code ............................................................................................................ 737
Section 22 Boundary Scan (JTAG)
Table 22.1 Pin Configuration.................................................................................................. 743