Datasheet

Section 22 USB Function Module (USB)
Rev. 2.00 Aug. 20, 2008 Page 839 of 1198
REJ09B0403-0200
22.3.5 Interrupt Select Register 1 (ISR1)
ISR1 selects the vector numbers of the interrupt requests indicated in interrupt flag register 1
(IFR1). If the USB issues an interrupt request to the INTC when a bit in ISR0 is cleared to 0, the
interrupt corresponding to the bit will be USBINTN2. If the USB issues an interrupt request to the
INTC when a bit in ISR0 is set to 1, the corresponding interrupt will be USBINTN3.
Bit Bit Name
Initial
Value
R/W Description
7 to 3  All 0 R Reserved
These bits are always read as 0. The initial value
should not be changed.
2 EP3 TR 1 R/W EP3 Transfer Request
1 EP3 TS 1 R/W EP3 Transmission Complete
0 VBUSF 1 R/W USB Bus Connect
22.3.6 Interrupt Select Register 2 (ISR2)
ISR2 selects the vector numbers of the interrupt requests indicated in interrupt flag register 2
(IFR2). If the USB issues an interrupt request to the INTC when a bit in ISR0 is cleared to 0, the
interrupt corresponding to the bit will be USBINTN2. If the USB issues an interrupt request to the
INTC when a bit in ISR0 is set to 1, the corresponding interrupt will be USBINTN3.
Bit Bit Name
Initial
Value
R/W Description
7 to 5  All 0 R Reserved
These bits are always read as 0. The initial value
should not be changed.
4 SURSE 1 R/W Suspend/Resume Detection
3 CFDN 1 R/W End Point Information Load End
2 SOF 1 R/W SOF Interrupt Detection
1 SETCE 1 R/W Set_Configuration Command Detection
0 SETIE 1 R/W Set_Interface Command Detection