Datasheet

Section 22 USB Function Module (USB)
Rev. 2.00 Aug. 20, 2008 Page 862 of 1198
REJ09B0403-0200
Register Bit
Transfer
Mode
Interrupt
Source
Description
Interrupt
Request Signal
DTC Activation
0 SETI Set_Interface
command detection
USBINTN2 or
USBINTN3
×
1
Status
SETC Set_Configuration
command detection
USBINTN2 or
USBINTN3
×
2 — SOF SOF interrupt
detection
USBINTN2 or
USBINTN3
×
IFR2
3 CFDN Endpoint information
load end
USBINTN2 or
USBINTN3
×
4
Status
SURSF Suspend/resume
detection
USBINTN2,
USBINTN3, or
RESUME
×
5 SURSS Suspend/resume
status
— ×
6
7
— Reserved —
— —
Note: * EP0 interrupts must be assigned to the same interrupt request signal.
• USBINTN0 signal
DTC start interrupt signal only EP1. See section 22.8, DTC Transfer.
• USBINTN1 signal
DTC start interrupt signal only EP1. See section 22.8, DTC Transfer.
• USBINTN2 signal
The USBINTN2 signal requests interrupt sources for which the corresponding bits in interrupt
select registers 0 to 2 (ISR0 to ISR2) are cleared to 0. The USBINTN2 is driven low if a
corresponding bit in the interrupt flag register is set to 1.
• USBINTN3 signal
The USBINTN3 signal requests interrupt sources for which the corresponding bits in interrupt
select registers 0 to 2 (ISR0 to ISR2) are cleared to 0. The USBINTN3 is driven low if a
corresponding bit in the interrupt flag register is set to 1.
• RESUME signal
The RESUME signal is a resume interrupt signal for canceling software standby mode. The
RESUME signal is driven low at the transition to the resume state for canceling software
standby mode.