Datasheet
R01DS0190EJ0100 Rev.1.00 Page 4 of 107
Jun 19, 2013
RX111 Group 1. Overview
Communication
function
USB 2.0 host/function
module (USBc)
USB Device Controller (UDC) and transceiver for USB 2.0 are incorporated.
Host (32-Kbyte or more ROM)/function module: 1 port
Compliant with USB version 2.0
Transfer speed: Full-speed (12 Mbps), low-speed (1.5 Mbps)
OTG (ON-The-Go) is supported.
Isochronous transfer is supported.
BC (Battery Charger) is supported.
12-bit A/D converter (S12ADb)
1 unit (1 unit × 14 channels)
12-bit resolution
Minimum conversion time: 1.0 µs per channel when the ADCLK is operating at 32 MHz
Operating modes
Scan mode (single scan mode, continuous scan mode, and group scan mode)
Double trigger mode (duplication of A/D conversion data)
A/D conversion start conditions
A software trigger, a trigger from a timer (MTU), an external trigger signal, or ELC
Temperature sensor (TEMPSa)
1 channel
The voltage of the temperature is converted into a digital value by the 12-bit A/D converter.
D/A converter (DA)
2 channels
8-bit resolution
Output voltage: 0 V to VCC
CRC calculator (CRC)
CRC code generation for arbitrary amounts of data in 8-bit units
Select any of three generating polynomials:
X
8
+ X
2
+ X + 1, X
16
+ X
15
+ X
2
+ 1, or X
16
+ X
12
+ X
5
+ 1
Generation of CRC codes for use with LSB-first or MSB-first communications is selectable.
Data operation circuit (DOC) Comparison, addition, and subtraction of 16-bit data
Power supply voltages/Operating frequencies VCC = 1.8 to 2.4 V: 8 MHz, VCC = 2.4 to 2.7 V: 16 MHz, VCC = 2.7 to 3.6 V: 32 MHz
Supply current 3.2 mA at 32 MHz (typ.)
Operating temperature range D version: 40 to +85°C, G version: 40 to +105°C
Packages 64-pin LFQFP (PLQP0064KB-A) 10 × 10 mm, 0.5 mm pitch
64-pin LQFP (PLQP0064GA-A) 14 × 14 mm, 0.8 mm pitch
64-pin WFLGA (PWLG0064KA-A) 5 × 5 mm, 0.5 mm pitch
48-pin LFQFP (PLQP0048KB-A) 7 × 7 mm, 0.5 mm pitch
48-pin HWQFN (PWQN0048KB-A) 7 × 7 mm, 0.5 mm pitch
40-pin HWQFN (PWQN0040KC-A) 6 × 6mm, 0.50mm pitch
36-pin WFLGA (PWLG0036KA-A) 4 × 4 mm, 0.5 mm pitch
On-chip debugging system E1 emulator (FINE interface)
Table 1.1 Outline of Specifications (3/3)
Classification Module/Function Description