User guide

64
SmartBook for Renesas R8C/Tiny Microcontrollers
www.MightyMicons.com
Programmable one shot generation mode: This mode generates a one shot
pulse under the control of either software or the hardware trigger.
Programmable wait one shot generation mode: A mono shot pulse is
generated with a definable delay after getting the trigger command.
Input capture mode: In this mode, counting of the timer is captured with reference
to the presence of the active input pulse signals at the timer input pins.
Output compare mode: This mode generates square pulses at the output pins
when the timer contents match with the data stored in the compare registers.
PWM mode: The micon generates continuous output waveform with the
programmable duty cycle.
Reset synchronous PWM mode: The micon generates the 3 Phase PWM with
sawtooth wave modulation without any dead time.
Complementary PWM mode: Micon generates 3 Phase PWM with sawtooth
wave modulation with the dead time.
PWM2 Mode: Micon generates PWM or the one shot output after getting a trigger.
PWM3 Mode: The micon generates two independent PWM outputs with same
period.
Real time clock mode: Under this mode, the micon generates periodical
interrupts using internal clock signals to indicate real time functions.
The following table gives an idea on the timer functions of the first generation
R8C/Tiny devices: