User`s manual

1.2 Connecting the Emulator with the User System

To connect the E10A-USB emulator (hereinafter referred to as the emulator), the H-UDI port

connector must be installed on the user system to connect the user system interface cable. When

designing the user system, refer to the recommended circuit between the H-UDI port connector

and the MCU. In addition, read the E10A-USB emulator user's manual and hardware manual for

the related device.

Table 1.2 shows the type number of the emulator and the corresponding connector type.

Table 1.2 Type Number and Connector Type

Type Number Connector

HS0005KCU01H, HS0005KCU02H 14-pin connector

1.3 Installing the H-UDI Port Connector on the User System

Table 1.3 shows the recommended H-UDI port connector for the emulator.

Table 1.3 Recommended H-UDI Port Connector

Connector Type Number Manufacturer Specifications

14-pin connector 2514-6002 Minnesota Mining &

Manufacturing Ltd.

14-pin straight type

Note: When designing the 14-pin connector layout on the user board, do not place any

components within 3 mm of the H-UDI port connector.

1.4 Pin Assignments of the H-UDI Port Connector

Figure 1.1 shows the pin assignments of the H-UDI port connector.

Note: Note that the pin number assignments of the H-UDI port connector shown on the

following page differ from those of the connector manufacturer.