Technical information

21
5. If the settings of the Event condition or the sequential conditions are changed during
execution of the program, execution will be suspended. (The number of clocks to be
suspended during execution of the program is a maximum of about 52 bus clocks (Bφ).
If the bus clock (Bφ) is 10.0 MHz, the program will be suspended for 5.2 μs.)
6. If the settings of Event conditions or the sequential conditions are changed during
execution of the program, the emulator temporarily disables all Event conditions to
change the settings. During this period, no Event condition will be satisfied.
7. If the satisfaction is contended between the DMA or DTC transfer and conditions of
Event Condition including the external bus access condition, the followings may be
disabled: generation of a break after the satisfaction of conditions of Event Condition,
halting and acquisition of the internal trace, and the start or end of performance
measurement.
8. When the emulator is being connected, the user break controller (UBC) function is not
available.
2.2.2 Trace Functions
The emulator supports the trace functions listed in table 2.9.
Table 2.9 Trace Functions
Function Internal Trace AUD Trace
Branch trace Supported Supported
Memory access trace Supported Supported
Software trace Not supported Supported
Table 2.10 shows the type numbers that the AUD function can be used.
Table 2.10 Type Number and AUD Function
Type Number AUD Function
HS0005KCU01H Not supported
HS0005KCU02H Supported
The internal and AUD traces are set in the [Acquisition] dialog box of the [Trace] window.