Technical information

Section 1 System Configuration
Rev. 2.00 Feb. 18, 2009 Page 7 of 94
REJ10J1938-0200
Table 1.3 System Configuration Supported by the SH72546RFCC/SH72544R/SH72543R
E200F (Cont)
E200F
Emulator
Profiling
expansion unit
Trace cable Expansion
AUD
Trace Unit
Emulation
Memory Unit
Ev-chip Unit User System
Interface Cable
R0E0200F1EMU00 R0E0200F0EPU00 R0E0200F0ACC00 R0E0200F1ATU00 R0E0200F1MSR00
R0E0200F1MSR01
R0E5725460VKK00 R0E0200F1CKL10
R0E572546CBF10
*1
System
configu-
ration 10
Supported Supported Supported Not supported Not supported Supported
Supported
System
configu-
ration 11
Supported Supported Supported Supported Not supported Supported Not Supported
System
configu-
ration 12
Supported Supported Supported Supported Not supported Supported Supported
System
configu-
ration 13
Supported Supported Supported Supported Supported Supported Not supported
System
configu-
ration 14
Supported Supported Supported Supported Supported Supported Supported
Note 1: As the user system interface cable, be sure to use both the R0E0200F1CKL10 and
R0E572546CBF10 at the same time.
The user system interface cable is only used when the emulator is connected to the user
system; it is not required when the emulator system operates alone.
Note 2: To configure a system without using the EV-chip unit, the H-UDI port connector must be
installed on the user system. For design of the user system, refer to section 2.3, Connecting
the Emulator to the User System by Using the H-UDI Port Connector. Note that when a
system is configured in this way, the H-UDI pins or AUD pins of the device will be occupied.