Technical information

Section 1 System Configuration
Rev. 2.00 Feb. 18, 2009 Page 8 of 94
REJ10J1938-0200
(2) System Configuration of the SH72531 and SH72531FCC
Table 1.4 shows the system configuration supported by the SH72531 and SH72531FCC.
Table 1.4 System Configuration Supported by the SH72531/SH72531FCC E200F
E200F
Emulator
Profiling
expansion unit
Trace cable Expansion
AUD
Trace Unit
Emulation
Memory Unit
Ev-chip Unit User System
Interface Cable
R0E0200F1EMU00 R0E0200F0EPU00 R0E0200F0ACC00 R0E0200F1ATU00 R0E0200F1MSR00
R0E0200F1MSR01
R0E5725460VKK00 R0E0200F1CKL10
R0E572531CFK10
*1
System
configu-
ration 1*
2
Supported Not supported Not supported Not supported Not supported Not supported Not supported
System
configu-
ration 2
Supported Not supported Supported Not supported Not supported Supported Not supported
System
configu-
ration 3
Supported Not supported Supported Not supported Not supported
Supported
Supported
System
configu-
ration 4
Supported Not supported Supported Supported Not supported
Supported
Not supported
System
configu-
ration 5
Supported Not supported Supported Supported Not supported
Supported
Supported
Note 1: For the user system interface cable, be sure to use both R0E0200F1CKL10 and
R0E572531CFK10 as a set.
The user system interface cable is only used when the emulator is connected to the user
system; it is not required when the emulator system operates alone.
Note 2: To configure a system without using the EV-chip unit, the H-UDI port connector must be
installed on the user system. For design of the user system, refer to section 2.3, Connecting
the Emulator to the User System by Using the H-UDI Port Connector. Note that when a
system is configured in this way, the H-UDI pins of the device will be occupied.