Technical information

Section 3 Software Specifications when Using the SH72546RFCC, SH72544R, SH72543R, SH72531, and SH72531FCC
Rev. 2.00 Feb. 18, 2009 Page 82 of 94
REJ10J1938-0200
The contents of the [Eva Board] page are shown below.
[Change
Emulation in start
up] check box
Displays the [Select Emulation] dialog box when the emulator is activated by
connecting the EV-chip unit.
Enables or disables output of the reset and NMI signals from the user system.
User Reset
enable:
Enables output of the reset signal from the user system.
[User Signals]
check boxes
User NMI enable: Enables output of the NMI signal from the user system.
[Multiplexed pins
setting…] list box
Selects usage or non-usage of the pin functions that have been set in the pin
function controller (PFC). This has the following function if all correspondences
between pins and signals are the same as those set up by the PFC:
• Monitoring function
Set this up allowing pin usage as set up in the PFC by the user program.
“pin name” (used): Select this item when “pin name” has been set in the PFC
by the user program and is to be used as such.
“pin name”
(unused):
Select this item when “pin name” has been set in the PFC
by the user program but is not to be used as such.
[Multiplexed pins
setting…(CSn)]
button
Opens the [Multiplexed pins setting…] dialog box, in which the states of usage for
multiplexed pins can be set (only CSn is available).