Datasheet

TK-850/JG3H User’s Manual

- 2 -

Windows and Windows XP are registered trademarks or trademarks of Microsoft Corporation in the United States and/or

other countries.

・The information is subject to change without notice.

・No part of this document may be copied or reproduced in any form or by any means without prior written consent

of TESSERA TECHNOLOGY INC.. TESSERA TECHNOLOGY INC. assumes no responsibility for any errors that

may appear in this document.

・TESSERA TECHNOLOGY INC. does not assume any liability for infringement of patents, copyrights or other

intellectual property rights of third parties by or arising from the use of TESSERA TECHNOLOGY INC. products

listed in this document or any other liability arising from the use of such products. No license, express, implied or

otherwise, is granted under any patents, copyrights or other intellectual property rights of TESSERA

TECHNOLOGY INC. or others.

・Descriptions of circuits, software and other related information in this document are provided for illustrative

purposes in semiconductor product operation and application examples. The incorporation of these circuits,

software and information in the design of a customer's equipment shall be done under the full responsibility of the

customer. TESSERA TECHNOLOGY INC. assumes no responsibility for any losses incurred by customers or third

parties arising from the use of these circuits, software and information.

CAUTION

・Do not give any physical damage to this equipment such as dropping

・Do not superimpose voltage to this equipment.

・Do not use this equipment with the temperature below 0℃ or over 40℃.

・Make sure the USB cables are properly connected.

・Do not bend or stretch the USB cables.

・Keep this equipment away from water.

・Take extra care to electric shock.

・This equipment should be handled like a CMOS semiconductor device. The user must take all precautions to

avoid build-up of static electricity while working with this equipment.

・All test and measurement tool including the workbench must be grounded.

・The user/operator must be grounded using the wrist strap.

・The connectors and/or device pins should not be touched with bare hands.