Datasheet

TK-850/JG3H User’s Manual
- 57 -
4.2.2 "Incorrect ID Code." (Ff603)
This error occurs when the security ID stored on microcontroller built-in flash memory is different
from the ID code you entered at the start of debugger.
Security ID entry area at the start of debugger
Check Point 1
Enter correct security ID and click OK on the configuration window.
Check Point 2
If you forgot the security ID, you have to erase the microcontroller built-in flash memory. Before
erasing, check if you actually set the security ID with referring to "2.5 Set Options
". Also
remember the code you set for the security ID.
After this, erase the flash memory with referring to "5.4 WriteEZ1
".
4.3 Monitor memory cannot be accessed. (F0c72)
Check Point 1
Check if the settings of switches on the kit are correct with referring "2.7 Check Board Settings
".
Check Point 2
Erase the flash memory with referring to "5.4 WriteEZ1
".
Check Point 3
If above 2 check points are confirmed, disconnect the USB cable from PC and re-connect again.
And, retry starting the debugger.