Datasheet

R01DS0041EJ0150 Rev.1.50 Page 135 of 221
Oct 18, 2013
RX210 Group 5. Electrical Characteristics
Figure 5.44 Ripple Waveform
Table 5.25 DC Characteristics (24)
Conditions: VCC = AVCC0 = 1.62 to 5.5 V, VSS = AVSS0 = VREFL0 = 0 V, T
a
= –40 to +105°C
The ripple voltage must meet the allowable ripple frequency f
r(VCC)
within the range between the VCC upper limit
(5.5 V) and lower limit (1.62 V).
When VCC change exceeds VCC ±10%, the allowable voltage change rising/falling gradient dt/dVCC must be met.
Item Symbol Min. Typ. Max. Unit Test Conditions
Allowable ripple frequency f
r(VCC)
— — 10 kHz Figure 5.44
VCC × 0.1 < V
r(VCC)
≤ VCC × 0.2
— — 1 MHz Figure 5.44
VCC × 0.05 < V
r(VCC)
≤ VCC × 0.1
— — 10 MHz Figure 5.44
V
r(VCC)
≤ VCC × 0.05
Allowable voltage change rising/
falling gradient
dt/dVCC 1.0 — — ms/V When VCC change exceeds VCC ±10%
Table 5.26 Permissible Output Currents (1)
Conditions: VCC = AVCC0 = 1.62 to 5.5 V, VSS = AVSS0 = VREFL = VREFL0 = 0 V, when total power (mW) < 1000 – 10 × Ta
Item Symbol Max. Unit
Permissible output low current
(average value per 1 pin)
Normal output mode I
OL
4.0 mA
High-drive output mode 8.0
Permissible output low current
(maximum value per 1 pin)
Normal output mode 4.0 mA
High-drive output mode 8.0
Permissible output low current (total) Total of all output pins
I
OL
80 mA
Permissible output high current
(average value per 1 pin)
Normal output mode I
OH
–4.0 mA
High-drive output mode –8.0
Permissible output high current
(maximum value per 1 pin)
Normal output mode –4.0 mA
High-drive output mode –8.0
Permissible output high current (total) Total of all output pins
I
OH
–80 mA
V
r(VCC)
VCC
1/f
r(VCC)