Datasheet

5. PC User Interface (GUI)
The User Interface is installed automatically during the CD-ROM installation.
The PC Interface uses the USB connection to communicate with the RL78G14 board so before use please make sure
that the Virtual UART drivers are installed as described in section 1.1.1
5.1. Launching the PC User Interface (GUI)
Note that for Windows Vista and Windows 7 it is necessary to run the GUI as “Run as administrator”
It is possible to set the operation to permanently enable the “Run as administrator” option in the windows start
menu. To enable this option perform the following sequence
a. Right click on the “motor Control Demo” icon
b. Select Properties
c. Select Advanced
d. Click the “Run as administrator” button
e. Press “OK” twice to return
To open the PC GUI click on the “Motor Control Demo” ICON in the start menu.
The GUI should open as shown below