Datasheet

Once the motor is in operation the graphs will start to update together with the measured values in the
“PROERTY MONITOR” window as shown below
d. Alarm Codes
There are three “alarm codes used in the GUI and embedded software
1. EEPROM error alarm
2. Inverter error
3. Loss of phase error
The alarm codes usually can be cleared by resetting the motor speed back to zero. In some
circumstances it is necessary to perform a manual reset of the RL78/G14 to clear the error. This may
reset the connection between the board and the GUI.
e. Saving Monitor Property Data to a file
It is possible to save the measured data displayed in the “PROPERTY MONITOR” window to a
“comma separated values` (csv) excel file for offline analysis and review
This is started by clicking the “Save Data to file” button located at the bottom of the “PROPERTY
MONITOR” window.