Datasheet

1. Installation and Set-Up
The following section provides the information to install the software, projects and documentation for the
YRMCKITRL78G14 motor control kit and to be able to set up the hardware in order to run the built in
demonstration.
1.1. Software Installation
To install the software supplied with the kit, Place the CD-ROM into the PC drive
The installation should start automatically
If for any reason the CD fails to start automatically, please run the “setup.exe” file on the CD
Windows™ Vista and 7 users may see “User Account Control” dialog box. If applicable, enter the administrator
password and click <OK>. It is recommended that the user has sufficient administration rights to install the
software on the CD. The following shall be installed:
The following software shall be installed or copied onto the user’s PC
 Motor Control GUI
 IAR Embedded Workbench including documentation
 Renesas Flash Programmer including documentation
 RL78 IEC Self-Test Software (Source code) including documentation
 YRMCKITRL78G14 IAR Embedded Workshop motor control project
 Renesas Manual Navigator
 Virtual UART USB Drivers
Please note that the IAR Embedded Workbench will require license registration. Please follow the instructions
during installation and ensure no other instance of the IAR Embedded Workbench is open.
The YRMCKITRL78G14 documentation shall be copied during installation and is designed to be viewed with the
Manual Navigator which is installed with this kit.
The following documentation shall be copied onto the user’s PC
 RL78/G14 user manual
 uPD0730 USB user manual
 RJK0654DPB Power MosFet user manual
 YRMCKITRL78G14 motor control kit user manual (This document)
 YRMCKITRL78G14 design files and schematics
 YRMCKITRL78G14 Quick start guide
 15V BLDC Demonstration motor data sheet
 E1 On chip debug/programmer user manual
 Environmental documents (WHEE, RoHS)
Before any of the software can be used the Virtual UART USB drivers need to be installed
Two copies of the drivers are included in the installation process
 YRMCKITRL78G14 kit installation
 During the IAR Embedded Workbench Installation
Depending on the Windows operating system, the drivers should be used as follows