Datasheet

16. Renesas Flash Programmer Usage
The following section how to set up and use the Renesas Flash Programmer interface (RFP) with the
YRMCKITRL78G14 motor control kit.
Before connecting the USB cable to the board and the PC, ensure that the jumpers are set as below
Jumpers JP3, JP4, JP5, JP6 and JP7 Pins 1–2 connected
Jumper JP1 and JP2 can be connected either as 1-3 or 4-6
Please note that if an external power supply is used JP1 and JP2 should both be set to position 1-2 which isolates the
USB interface, so that it is safe to connect to the PC.
Please make sure that the USB cable is plugged into the PC and that the board is connected.
The RFP will have been installed in the default location
Start Menu =>
All programs =>
Renesas =>
Renesas Flash Programmer (V1.03.00) =>
Renesas Flash Programmer (V1.03.00).exe
Double click on the file to open. (Note that Windows Vista and 7 users may have to use “Run as administrator”) and the
opening screen should open as below
Click the “Next” button to start the set-up process