Datasheet

The hex file to be programmed needs to selected
Press the “Browse” button and locate the hex file to be programmed into the RL78/G14.
Follow the instructions to select the file. The file name should appear in the User/Data area as shown below
Next the command needs to be set
Press the “Microcontroller” menu button and select the “Autoprocedure (E.P)” option.
This will execute the following sequence when the large “START” button is pressed.
Blank Check the Device =>
Erase the device if not blank =>
Program the device with the Hex code selected
If the user is unsure of the use of the RFP process then a different command such as “Blank Check” or “Signature
Read” can be performed. This will confirm that the communication interface is working and that the RFP can connect
to the RL78/G14 on the board without corrupting or damaging the device.
If everything is correct then the command can be changed to “Autoprocedure (E.P)” and the device can be programmed
with the selected Hex file.