Datasheet

To open the YRMCKITRL78G14 IAR motor control workspace and project follow the sequence shown below
File =>
Open =>
Workspace =>
C:\Workspace\YRMCKITRL78G14\ MCRP08_RL78G14obj_2.0\...=>
Select the “ MCRP08_RL78 ” IAR Workspace file =>
Press Open
The project should then open in the IAR IDE and should look something like the window below
Please note that depending on setting used previously then the IAR workspace and project windows can look slightly
different. All the settings have been pre-set so that the workspace appearance is as consistent as possible. For full details
of the IAR Embedded Workbench, please refer to the documentation included as part of the IAR installation
To open any of the source files listed in the project (on the Left Hand Side of the project window), just double click on
the relevant file.