Operator`s manual

Advanced Haas Mill Programming Techniques Training Manual Page 2
Advanced Haas Program Techniques
Haas Programmer Optimizer
The Haas Program Optimizer allows feed and speed overrides, coolant P changes, notes to be saved after a
program has been run for the first time. First the program is run in memory and any changes to speed or
feed are made thru the override keys. If the coolant position is not correct usually the machine is put on
Feed Hold and the P coolant position is adjusted using the CLNT UP or CLNT DOWN keys. If a coolant needs
to be turned on or off the machine is put on Feed Hold and the COOLNT key on the MDI mode line pressed.
A note can be made such as ADD PASS and the Enter key depressed. If a M01 needs to be changed to an
M00, this can also be noted.
To get into the Program Optimizer press the F4 key at the end of the program. The following screen will
come up in the Edit Mode. Toggling the EDIT key will make one or the other the active screen in white.
Note on blocks N5 thru N7 have asterisks on them. This indicates some change was made while the
program was run or a note was added.
Pressing the EDIT key will make the right side of the screen active. Then highlight in yellow the F 110% and
press the ENTER key. The following pop will appear. Using the up and down cursor key gives different
options. Text below the line elaborates on the different selections. The Alter Feed on current line was
highlighted in yellow and selected. Pressing the Enter key will alter the feed on the current line.