Operator`s manual

Advanced Haas Mill Programming Techniques Training Manual Page 76
Below is a fixture designed by Productivity’s Automation Department to hold two hydraulic vises. The
fixture is attaches to a Haas HRT210 on the right side with an A frame support on the left side.
Below shows the block to be machined in the vises. The right vise has the top orthogonal view. The left
vise has the back view but is rotated 90⁰.
The ¼ thru hole with 3/8 counter bore may be machined in the right vise. The 8-32 thread drilled and
tapped in vise on the left.
The rotary table is set up such that the front and back face may be machined as below. This angular
position will be set up as A0⁰.