User's Manual

3D Tool Setter Specifications
Principal Application Tool setting and broken tool detection on all sizes of machining centres
Dimensions Diameter 115.1 mm (4.53 in)
Height with disc stylus 101.75 mm (4.01 in)
Weight (without stylus)
With battery
Without battery
610 g (21.5 oz)
599 g (21.1 oz)
Transmission Type Frequency Hopping Spread Spectrum (FHSS) Radio
Radio Frequency 2400 MHz to 2483.5 MHz
Switch-on Methods Radio M Code
Switch-off Methods Radio M Code
Operating range Transmission range 10 m
Receiver/Interface Primo Interface - combined antenna, interface and receiver unit
Sense Directions Omni-directional ±X,±Y, ±Z
Uni-directional
Repeatability
Maximum 2σ value in any
direction
1.0 µm (0.00004 in)
Stylus Trigger Force 1.3 N to 2.4 N/130 gf to 240 gf (4.5 ozf to 8.5 ozf) depending on sense direction
Stylus Overtravel XY Plane ± 3.5 mm (0.14 in)
+Z Plane 5.5 mm (0.22 in)
Environment IP Rating IPX8 (EN/IEC60529)
Storage temperature -25 ˚C to +70 ˚C (-13 ˚F to +158 ˚F)
Operating temperature +5 ˚C to +55 ˚C (+41 ˚F to +122 ˚F)
Battery Types 1 x 3V CR2 Lithium Manganese Dioxide
or
1 x 3.6V ½ AA Lithium Thionyl Chloride (see section 6.4 for further details)
Battery Reserve Life Approximately one week after a low battery warning is first given
Typical Battery Life See table below
Low Battery Indication Flashing blue LED (probe seated)
Dead Battery Indication Continuous red LED
Low credit indication Flashing yellow LED (probe seated) 21 days before credit expires
No credit indication Continuous yellow LED
Battery Type
Turn-on Time Standby Life 5% Usage
(72 minutes/day)
Continuous use
CR2 Lithium Manganese
Dioxide
Part of alpha tests Part of alpha tests Part of alpha tests Part of alpha tests
½ AA Lithium Thionyl
Chloride
Part of alpha tests Part of alpha tests Part of alpha tests Part of alpha tests
Dimensions
& Specs
4.5