User's Manual

Preparing the 3D Tool Setter
for use
Fitting the stylus, break stem and
captive link (same diagram as below but with
Primo Tool Setter and showing compartment in the
back for spare break stem)
Stylus weak link break stem
Incorporated into the stylus, the break stem
protects the mechanism from damage in the event
of excessive stylus over travel or a collision. There
is a compartment in the back of the 3D Tool Setter
for a spare break stem to be stored.
Captive link
In the event of the break stem being damaged the
captive link ties the stylus to the probe.
NOTE:
Always hold the support bar in the position to
avoid over stressing the break stem.
System
installation
5.7
Primo installation guide