User's Manual

Calibration and measurement speeds
not the same
Review probing software
Calibration feature has moved Correct the position
Measurement occurs as stylus leaves
surface
Review software
Measurement occurs within the
machine’s acceleration and
deceleration zone
Review software and probe filter settings
Probing speed too high or too low Perform simple repeatability trials at
various speeds
Temperature variation causes machine
and workpiece movement
Minimise temperature changes
Machine tool faulty Perform health checks on machine tool
Part Setter status LEDs
do not correspond to
Interface LEDs
Radio link failure – Part Setter out of
Interface range
Check position of Part Setter
Part Setter has been enclosed/shielded
by metal
Remove from obstruction
Part Setter and Interface are not
partnered
Partner Part Setter and Interface
Interface error LED lit
during probing cycle
Part Setter not switched on or timed
out
Change setting. Review turn-off method
Part Setter out of range Check position of Interface
Interface low battery
LED lit
Low battery Change battery soon
Reduced range Local radio interference Identify and remove
Part Setter fails to
switch off
Incorrect switch-off method
configured
Check configuration and alter as required
No Interface ‘start/stop’ signal (radio-
on mode only)
Check Interface for green start LED
Incorrect spin speed Check spin speed