User Manual

Radio Part Setter Specification
Principle Application Work piece inspection and job set-up on all sizes of machining centres
Dimensions
Length
Diameter
61.25 mm (2.41 in)
51 mm (2.00 in)
Weight (no shank)
With battery and iButton
Without battery
360 g
349 g
Transmission Type Frequency Hopping Spread Spectrum (FHSS) Radio
Radio Frequency 2400 MHz to 2483.5 MHz
Switch-on Methods Radio M Code, Spin
Switch-off Methods Radio M Code, Spin
Spindle Speed (max) 1000 rpm not yet been tested
Operating Range Transmission range 10 m
Receiver/Interface Primo Interface - combined antenna, interface and receiver unit
Sense Directions Omni-directional ±X, ±Y, +Z
Uni-directional
Repeatability
Maximum 2σ value in any
direction
1.0 µm (0.00004 in) tested with 50mm stylus.
Stylus Trigger Force
XY Low Force
XY High Force
Z
0.5 N, 50 gf (1.76 ozf)
0.9 N, 90 gf (3.17 ozf)
5.85 N, 585 gf (20.63 ozf)
The stylus trigger force is the force exerted on the
component when the probe triggers. However, the
maximum force applied to the component will occur
after the trigger point and will be greater than the
trigger force. The magnitude depends on a number of
factors affecting probe overtravel including
measuring speed and machine deceleration. If the
forces applied to the component are critical, contact
Renishaw for further information.
Stylus Overtravel
XY Plane
+Z Plane
±12.5˚
6 mm (0.24 in)
Environment
(As defined in
BS EN 61010-1:2001)
IP rating IPX8 (BS5490, IEC 60529) 1 atmosphere
Storage temperature -25 ˚C to +70 ˚C (-13 ˚F to +158 ˚F)
Operating temperature +5 ˚C to +55 ˚C (+41 ˚F to +122 ˚F)
Battery Types 1 x 3V CR2 Lithium Manganese Dioxide
or
1 x 3.6V ½ AA Lithium Thionyl Chloride (see section 6.4 for further details)
Battery Reserve Life Approximately one week after a low battery warning is first given
Low Battery Indication Flashing blue LED whilst probe is seated (not triggered)
Dead Battery Indication Continuous red LED
Typical Battery Life See table below
Low credit indication Flashing yellow LED (probe seated) 21 days before credit expires
No credit indication Continuous yellow LED
Battery Type
Spin switch-on Radio switch-on Continuous
use
Standby life
5% usage
(72 mins/day)
Standby life 5% usage
CR2 Lithium Manganese
Dioxide
Part of alpha
tests
Part of alpha
tests
Part of alpha
tests
Part of alpha
tests
Part of alpha
tests
½ AA Lithium Thionyl
Chloride
Part of alpha
tests
Part of alpha
tests
Part of alpha
tests
Part of alpha
tests
Part of alpha
tests
Primo installation guide
Dimensions
& Specs
4.4