User Manual

Contents

Before you begin......................................................................................................................... 1.1

Before you begin....................................................................................................................1.1

Disclaimer................................................................................................................. 1.1

Trademarks............................................................................................................... 1.1

Warranty................................................................................................................... 1.1

Changes to equipment.............................................................................................. 1.1

CNC machines............................................................................................................1.1

Care of the Primo equipment................................................................................... 1.1

Patents................................................................................................................................... 1.2

EC declaration of conformity................................................................................................. 1.3

WEEE directive.......................................................................................................... 1.3

FCC declaration (US)................................................................................................. 1.3

Radio approvals..................................................................................................................... 1.4

Safety..................................................................................................................................... 1.5

Information to the equipment installer................................................................................. 1.6

Primo training programme.................................................................................................... 1.7

Radio Part Setter & Radio 3D Tool Setter Basics 2.1

Introduction........................................................................................................................... 2.1

Getting started.......................................................................................................... 2.1

Credit........................................................................................................................ 2.1

Modes of operation.................................................................................................. 2.1

Configurable settings............................................................................................................. 2.2

Switch on/switch off methods.................................................................................. 2.2

Enhanced trigger filter.............................................................................................. 2.2

Recalibration............................................................................................................. 2.2

Acquisition mode...................................................................................................... 2.2

Primo credit token................................................................................................................. 2.3

Upgrade credit token................................................................................................ 2.3

Credit transfer........................................................................................................... 2.3

Four low credit indicators......................................................................................... 2.3

Radio Part Setter & Radio 3D Tool Setter operation............................................................. 2.4

Achievable set-up tolerances.................................................................................... 2.4

Software routines.................................................................................................................. 2.5

Interface basics 3.1

Introduction........................................................................................................................... 3.1

Power supply............................................................................................................ 3.1

Input voltage ripple................................................................................................... 3.1

Contents