User Manual

Interface enters “Acquisition waiting”
Interface identifies probe
Acquisition complete (probe LED green 5 s)
Method of partnership
Both the Part Setter and the 3D Tool Setter can be partnered with the Primo interface simultaneously.
Turn the Primo Interface off and on to activate
Acquisition mode
Trigger the stylus again for more than 1 second
Primo installation guide
1)
1
)
Probe enters “Acquisition waiting”
Release stylus
Probe identifies Interface
Acquisition complete (LED green 5 s)
3
)
3
)
4
)
5
)
5
)
>1s
1. Remove betteries >5s
2. Trigger stylus and hold
3. Re
-
insert batteries
System
installation
5.19
Note:
Primo System Kits will be supplied with Equipment that has
already been acquired. Using this acquisition process will only
be needed when using replacement equipment or when
equipment has been bought separately.
2
)
2
)
Primo Radio Part Setter
Primo Radio
3D Tool Setter
Primo Radio Part Setter
Primo Radio Part Setter
Primo Radio
3D Tool Setter
Primo Radio
3D Tool Setter
Part setter identified,
3D Tool
Setter waiting
Part setter acquired
, 3D Tool
Setter waiting
1
2
3
1
2
3
A
Probe status check
LED check