User Manual

Trigger the stylus, the LED’s will
flash at an increasing rate; hold
the stylus until LED’s show solid
Yellow.
Method of credit transfer
Insert Primo credit token and
replace cover.
RGB start up LED signal.
This is followed by the 5 green
acquisition prompt flashes.
1)
2
)
The Part Setter has entered
credit transfer mode.
3
)
> 5s
4
)
Method of credit transfer
Credit transfer successful
indicated by
yellow/blue flashes. These flashes repeat 5
times. The
Interface display shows
credit.
Credit transfer unsuccessful
indicated by
yellow/red flashes. These flashes repeat 5 times.
Part Setter returns
to credit transfer mode.
5
)
5
)
NOTES:
If credit transfer is interrupted
after it’s been
initiated (stage 4), then credit transfer
must
completed on that system.
Once all the credit has been transferred
remove the token from the Primo Probe
.
A
indicated by
yellow/blue flashes. These flashes repeat 5
Interface display shows
remaining
indicated by
yellow/red flashes. These flashes repeat 5 times.
to credit transfer mode.
System
installation
5.21
after it’s been
must
be
Once all the credit has been transferred
do not
.