User Manual

3D Tool Setter status
LEDs do not correspond
to Interface LEDs
Radio link failure – 3D Tool Setter out
of Interface range
Check position of 3D Tool Setter
3D Tool Setter has been
enclosed/shielded by metal
Remove from obstruction
3D Tool Setter and Interface are not
partnered
Partner 3D Tool Setter and Interface
Interface error LED lit
during probing cycle
3D Tool Setter not switched on or
timed out
Change setting. Review turn-off method
Probe out of range Check position of Interface
Dead Interface batteries Change Interface batteries
3D Tool Setter and Interface not
partnered
Partner 3D Tool Setter and Interface
Interface low battery
LED lit
Low battery Change battery soon
Reduced range Local radio interference Identify and remove
Probe fails to switch off No Interface ‘start/stop’ signal (radio-
on mode only)
Check Interface for green start LED
Primo installation guide
Fault finding
7.2