User Manual

EC Declaration of conformity
Renishaw plc hereby declares that the Primo Radio
Part Setter, Radio 3D Tool Setter and Interface are
in compliance with the essential requirements and
other relevant provisions of Directive 1995/5/EC.
Contact Renishaw plc at www.renishaw.com for
the full EC Declaration of Conformity.
WEEE directive
The use of this symbol on Renishaw products
and/or accompanying documentation indicates
that the product should not be mixed with general
household waste upon disposal. It is the
responsibility of the end user to dispose of this
product at a designated collection point for waste
electrical and electronic equipment (WEEE) to
enable reuse or recycling. Correct disposal of this
product will help to save valuable resources and
prevent potential negative effects on the
environment. For more information, please
contact your local waste disposal service or
Renishaw distributor.
Battery disposal
The crossed out wheeled bin symbol on the
batteries used in this product indicate that
batteries must be collected and disposed of
separately from household waste in accordance
with EU battery directive 2006/66/EC . Please
contact your local authority about the rules on the
separate collection of batteries because correct
disposal helps to prevent negative consequences
for the environmental and human health.
FCC declaration (US)
FCC section 15.19
This device complies with Part 15 of the FCC rules.
Operation is subject to the two conditions:
1. This device may not cause harmful
interference.
2. This device may accept any interference
received, including interference that may
cause undesired operation.
FCC section 15.21
The user is cautioned that any changes or
modifications not expressly approved by Renishaw
plc, or an authorized representative, could void
the user’s authority to operate the equipment.
Before you
begin
1.3