User Manual

Acquisition mode
System Status
Graphic
display
Details
Part
Setter
Start
Low
battery/
credit
Probe
status
Error Signal
3D Tool
Setter
Interface in
“Acquisition
waiting” state
The Part Setter LEDs flash
yellow/off at least once for
up to 8s or until a Part
Setter is discovered
Interface
identifies Part
Setter*
The Part Setter LED flashes
green for up to 3 minutes or
until an “acquisition ready”
message is received from
the Part Setter
Interface
identifies 3D
Tool Setter
The 3D Tool Setter LED
flashes green for up to 3
minutes or until an
“acquisition ready” message
is received from the 3D Tool
Setter
Part Setter and
3D Tool Setter
identified
Both LEDs flash green for up
to three minutes or until an
“acquisition ready” message
is received from the
equipment
The Part Setter
is acquired (3D
Tool setter
acquisition
pending)
The part Setter LED is on, 3D
Tool Setter LED flashes for 3
minutes or until the 3D Tool
Setter is acquired
3D Tool Setter
acquired (Part
Setter
acquisition
pending)
The 3D Tool Setter LED is
on, the Part Setter LED
flashes for 3 minutes or until
the Part Setter is acquired.
Part Setter
acquired
Part Setter LED stays on for
5 sec
3D Tool Setter
acquired
3D Tool setter LED stays on
for 5 sec
Part Setter and
3D Tool Setter
acquired
Part Setter and 3D Tool
Setter LEDs stay on for 5 sec
Primo installation guide
System
installation
5.17