User's Manual
Manuals
Brands
Renishaw Manuals
Electronics
PROBE FOR MACHINE TOOLS
21
22
23
24
25
26
27
28
29
30
Table Of Contents
RLP40 - radio lathe probe installation guide
Before you begin
Before you begin
Disclaimer
Trademarks
Warranty
Changes to equipment
CNC machines
Care of the probe
Patents
EC Declaration of Conformity
WEEE DIRECTIVE
FCC DECLARATION (USA)
Radio approval
Safety
RLP40 basics
Introduction
Getting started
System interface
Trigger Logic™
Modes of operation
Configurable settings
Switch on/switch off methods
Enhanced trigger filter
Multiple probe mode
Acquisition mode
RLP40 dimensions
RLP40 specification
System installation
Installing the RLP40 with an RMI
Operating envelope
Performance envelope when using the RLP40 with the RMI
RLP40 / RMI positioning
Performance envelope
Preparing the RLP40 for use
Fitting the stylus
Installing the batteries
Mounting the probe on a shank
Stylus on-centre adjustment
Stylus trigger force adjustment
Calibrating the RLP40
Why calibrate a probe?
Calibrating in a bored hole or on a turned diameter
Calibrating the probe length
Trigger Logic™
Reviewing the current probe settings
Multiple probe settings
Probe settings record
Changing the probe settings
RLP40 – RMI partnership
Operating mode
Maintenance
Maintenance
Cleaning the probe
Changing the batteries
Battery type
RLP40 eyelid
Re-assembling the probe
Fault finding
Parts list
1
2
3.3
System
installation
Preparing the RLP40 f
or use
Fitting the stylus
M-5000-3707
1
...
...
19
20
21
22
23
...
...
46
