User's Manual

RLP40 installation guide
4.6
Trigger Logic™
RLP40 – RMI partnership
System set-up is achieved using Trigger Logic™
and powering the RMI. Partnering is only required
during initial system set-up. Further partnering
is only required if either the RLP40 or RMI is
changed, or a system is reconfigured for multiple
probes (multiple probe mode).
Partnering will not be lost by reconfiguring the
probe settings or when changing batteries, except
where multiple probe mode is selected. Partnering
can take place anywhere within the operating
envelope.
In configuration mode, configure the probe
settings as required until you reach the
"Acquisition mode" menu. Select "Acquisition
mode off".
Deflect the stylus to select 'Acquisition
mode on'.
Ensure this is done within 10 seconds
of the RMI signal LED flashing green.
SIGNAL LED
RMI in acquisition mode
3
3
The probe is in stand-by
and the system is ready
for use.
3
X
New partner RMP acquired
SIGNAL LED
> 20 s
Acquisition mode
off
Acquisition mode
Acquisition mode
on
NOTE: Once in ‘Acquisition
mode off’, ensure the next two
steps are completed within
20 seconds.
Switch on the RMI
< 4 s
X
3