User's Guide

12
MP18
dimensions mm (in)
B
A
9mm
(0.35in)
TAPER SHANK
The shank is attached to the
RMP3 using a shank adaptor.
Part No. A-2107-0031.
The method of attachment
is the same as used for other
Renishaw probes (MP7, MP8,
MP9 and MP10 compact
optical probes).
Shank assembly is shown
on page 14.
Probe ready shanks are
available from Renishaw.
Shank modification details for
shanks obtained from other
sources are given on page 35.
These shanks are not suitable for the MP18-S probes which use a dedicated shank incorporating a shank switch.
Shank Part No. Taper A B
M-2045-0132 30 20,0 (0.787) 9,6 (0.378)
M-2045-0024 40 13,6 (0.535) 11,6 (0.457)
M-2045-0025 45 15,2 (0.598) 15,2 (0.598)
M-2045-0026 50 15,2 (0.598) 15,2 (0.598)
M-2045-0064 30 35,25 (1.388) 19,0 - 19,1 (0.748 - 0.752)
M-2045-0065 40 35,25 (1.388) 19,0 - 19,1 (0.748 - 0.752)
M-2045-0066 45 35,25 (1.388) 19,0 - 19,1 (0.748 - 0.752)
M-2045-0067 50 35,25 (1.388) 19,0 - 19,1 (0.748 - 0.752)
M-2045-0137 40 35,25 (1.388) 19,0 - 19,1 (0.748 - 0.752)
M-2045-0138 45 35,25 (1.388) 19,0 - 19,1 (0.748 - 0.752)
M-2045-0139 50 35,25 (1.388) 19,0 - 19,1 (0.748 - 0.752)
M-2045-0077 30 27,5 (1.083) 27,5 (1.083)
M-2045-0027 40 32,0 (1.260) 32,0 (1.260)
M-2045-0038 45 33,0 (1.299) 33,0 (1.299)
M-2045-0073 50 38,0 (1.496) 38,0 (1.496)
DIN 2080
DIN 69871
ANSI B5.50
1985 (CAT)
BT
Probe-ready shanks available from Renishaw
Please quote the Part No. when ordering equipment
Shank adaptor
RMP3
Taper
shank
17.5° 17.5°
21,5
(0.85)
Ø62
(Ø2.24)
Stylus
length
Ø48 (Ø1.89)
95mm
(3.74in)
29
(1.14)
22
(0.87)
85
(3.35)
Ø6 (Ø0.24)
LED x 4
optical
switch on/off
STATUS LED
Green - stylus seated
Red - stylus deflected
PROGRAMMING LED