User's Guide

26
The MI16 Interface and probe/RMP3
transmission module are factory set to
Channel 1. The following procedure
must be followed to set or change the
transmission channel.
The programming of the transmission
channel and the RMP3 activation mode
MODE AND CHANNEL SELECTION
1. The programming mode is entered by
pressing simultaneously the programming
‘+’ and ‘–’ buttons on the front of the MI16
Interface, for approximately 5 seconds.
The Channel Number and Activation Mode
displays will start to flash, to indicate that the
Interface is ready to be programmed.
2. Select the required channel by using the
‘+’ button to increase the channel number,
and the ‘-’ button to reduce the channel
number. 40 channels are available.
3. To change the activation method,
simultaneously press both the ‘+’ and ‘-’
buttons. Each simultaneous press will cause
the activation method to change. The MI16
can be cycled through all the available
activation methods.
is carried out on the MI16 and transferred
to the RMP3 by a short range optical link.
To program the RMP3 it is necessary to bring
the RMP3 close to the front panel of the MI16
Interface. This should be catered for when
selecting the MI16 Interface mounting and
positioning.
4. When a Mk2 MI16 is used, the mode selection
will select 30 sec (± 1sec) time out when the
time out LED is green, or 180 sec (± 1sec)
when the time out LED is red.
5. If neither key is pressed for 5 seconds the
channel number stops flashing, followed by a
double audible beep, and the ‘CONFIRM’ LED
lighting on the MI16 Interface front panel for a
period of 10 seconds. This indicates that
programming of the interface is complete.
If only a change in channel is required, with
no change in activation method, action 5.
may be taken after action 2.
PROGRAMMING THE MI16 INTERFACE
+
–
CHANNEL NUMBER
DISPLAY
CONFIRM LED
ACTIVATION
MODES