User's Manual

RMP40 installation guide
3.4
System installation
Installing the batteries
1
2
3
NOTES:
See Section 5 - Maintenance for list of suitable
battery types.
When inserting batteries, check that the battery
polarity is correct.
If dead batteries are inadvertently inserted into
the probe then the LEDs will remain a constant
red, see page 4.4.
Do not allow coolant or debris to enter the
battery compartment.
After inserting the batteries the LEDs will display
the current probe settings (for details see
Section 4 - Trigger Logic™).
Please remove battery
isolation device from the
battery compartment,
before use.