User's Manual
Manuals
Brands
Renishaw Manuals
Electronics
PROBE FOR MACHINE TOOLS
31
32
33
34
35
36
37
38
39
40
Table Of Contents
RMP40 radio machine probe installation guide
Before you begin
Before you begin
Disclaimer
Trademarks
Warranty
Changes to equipment
CNC machines
Care of the probe
Patents
EC Declaration of Conformity
WEEE DIRECTIVE
FCC DECLARATION (USA)
Radio approval
Safety
Information to the user
Information to the machine supplier/ installer
Information to the equipment installer
Equipment operation
RMP40 basics
Introduction
Getting started
System interface
Trigger Logic™
Modes of operation
Configurable settings
Switch on/switch off methods
Enhanced trigger filter
Multiple probe mode
Acquisition mode
System installation
Installing the RMP40 with an RMI
RMP40 specification
RMP40 dimensions
System installation
Installing the RMP40 with an RMI
Operating envelope
Performance envelope when using the RMP40 with the RMI
RMP40 / RMI positioning
Performance envelope
Preparing the RMP40 for use
Fitting the stylus
Installing the batteries
Mounting the probe on a shank
Stylus on-centre adjustment
Calibrating the RMP40
Why calibrate a probe?
Calibrating in a bored hole or on a turned diameter
Calibrating in a ring gauge or on a datum sphere
Calibrating the probe length
Trigger Logic™
Reviewing the current probe settings
Multiple probe settings
Probe settings record
Changing the probe settings
RMP40 – RMI partnership
Operating mode
Maintenance
Maintenance
Cleaning the probe
Changing the batteries
Battery type
RMP40M system
RMP40M system
RMP40M dimensions
RMP40M screw torque values
Fault finding
Parts list
RMP40 installation guide
4.8
T
rigger Logic™
This page left intentionally blank
1
...
...
32
33
34
35
36
...
...
48
