User's Manual

18
Changing probe settings
1. Insert the batteries, or if already inserted,
remove for 5 seconds and replace.
2. Deflect the stylus and hold deflected until
5 red flashes occur at end of the review
sequence.
Changing probe settings
3. The probe will now be in the configuration
mode and the current switch on method will
flash. The probe settings can be changed as
shown below.
Note:
If battery power is low then each of the
5 red flashes will be followed by a blue flash.
See ‘Probe settings’ for further details.
Note:
Settings are saved as they are changed
Probe settings can be configured using the
trigger logic.
4. To exit the trigger logic at any point, leave
the stylus undeflected for over 20 seconds.
5. Settings record table
For quick reference, Renishaw suggest
that you record your settings in the table
at the back of this guide.
These settings will be needed if the probe
is replaced.