User's Manual

24
RMP60 batteries
Replacing batteries
Only use specified batteries.
Clean and dry the RMP60 with a cloth or paper
towel before removing the battery cover. Where
the RMP60 has been exposed to coolant, it is
recommended that the area around the battery
cover is cleaned.
To access the RMP60 batteries, remove the
battery cover by rotating the securing screw 30°
anticlockwise and withdraw the battery cassette.
Take care to avoid damaging the cover gasket.
When inserting the batteries, ensure they are
loaded as shown (see next page).
If one or more batteries are incorrectly loaded
the probe will not respond.
RMP60 batteries
Do not mix new and used batteries or battery
types, as this will result in reduced life and
damage to the batteries.
Always ensure that the cover gasket and mating
surfaces are clean and free from damage before
reassembly.