User's Manual

36
Fault-finding
Fault finding - If in doubt, consult your probe supplier.
Dead batteries.
Batteries incorrectly
inserted.
Probe out of range
No RMI ‘start/stop’ signal
(radio-on mode only)
Incorrect spin speed
(spin switch on only).
Malfunctioning shank switch
(shank switch mode only).
Incorrect switch on method
configured.
Incorrect Multiple Probe Mode
setting configured
RMP60 in hibernate mode
(radio-on mode only).
RMP60 fails to switch on.
Change batteries.
Check/change batteries.
Check position of RMI,
see Operating envelope.
Check RMI for green start LED.
Check spin speed.
Check switch operation.
Check configuration and alter
as required.
Check configuration and alter
as required.
Ensure probe is in range
and wait up to 30 seconds.
Check position of RMI,
see Operating envelope.
Sympton Cause Action