User manual

22
8. Commissioning
• Switchothegardenpump.
• Checktheconditionofthewaterlterandcleanitunderclean,cold,runningwaterifrequired.Then
insert the water filter again and screw the closure cap on tight.
• Ifyouhavenotdonesoyet,connectthesuctionhosetotheintakeopening.Useacoarselteranda
backowstopattheendofthesuctionhose.
 Foraneasierandfastersuctionprocess,llthehoseandgardenpumpwithcleanwater;this
applies specifically for larger suction heights.
• Connect,e.g.,yourgardenwateringsystem,totheoutletopening.
• Plugthemainsplugintoapropermainssocketwithaprotectivegroundcontact.
The mains plug must only be plugged into the mains socket when dry. There is danger to life from
electric shock otherwise!
• Switchonthegardenpump.Thegardenpumpstartstoworknow.
If the suction hose and the garden pump were filled with water as described above, the garden pump
should convey water at the outlet side after a few seconds.
Open the connected spray, shower, watering rod or sprinkler so that air can escape and water can be
conveyed.
• Thegardenpumpiscooledatthesametimeaswaterisconveyed.Nevertheless,thegardenpumpisnot
suitable for continuous operation. We recommend switching o the garden pump after no more than 60
minutes and to let it cool o entirely before it is reused.
If no water is conveyed, there is still air in the garden pump and the hose. If no water is conveyed
after as much as one minute, switch o the garden pump.
 Insertabackowstopattheendofthesuctionhose(e.g.inawell).Thisfacilitatesthesuction
process specifically at higher overheads.
Fill the suction hose and the garden pump with clear water and restart pumping.