User manual

8. Installation and rack mounting

Do not install the receiver station on a soft surface such as carpets or beds, etc.

 Makesuretherearenootherdeviceswithstrongelectricormagneticeldsinthenearproximity,suchas

transformers, engines, wireless telephones, radio equipment, etc. They could affect the device.

The product might also be affected by interferences (radiation) caused by tuners, TV sets, etc. Keep a

distance as big as possible to such devices. Metal surfaces, reinforced concrete walls, etc. located within

the transmission range can also reduce the range.

 Neverplacethedeviceonvaluableorsensitivefurnituresurfaceswithoutusingsufcientprotection.

Please make sure to install the receiver station with an optimum clearance of at least 100 cm to all sides.

• Place the device on a stable, clean, dry, at and horizontal

surface.

• The delivery scope includes two mounting brackets with screws

for rack mount installation. Screw one bracket onto each side,

as illustrated in the adjacent picture.

- Rotate the bracket by 180° if needed.

9. Connection and preparation

a) Connecting the receiver station

Only use suitable, isolated XLR or jack cables for connecting the outputs. Using other cables could cause

malfunction.

In order to avoid distortion or mismatch, only use suitable and matching cables. It is important to read and

observe all instructions in the user manuals of the devices to be connected.

• Turn off the receiver station (POWER on/off button (3) to 0 position) and disconnect the mains adapter from the

mains.

• Turn off the audio device (mixer, or similar) to be connected to the receiver station, and disconnect it from the mains.

• Connect the audio input/s of your audio device to the audio outputs of the receiver station:

- In order to separately transmit the signals of both transmitters, connect the XLR sockets CH.A (10) and CH.B (9)

to two inputs of the audio device (e.g. mixer).

- In order to jointly transmit the signals of both transmitters, connect the 6.35 mm audio cable to the MIX OUTPUT

jack socket (11) and to a suitable input of the audio device.