User manual

48
To copy an album:
• Switch to CD mode. If playback starts automatically, press the button (9) to stop playback.
• Use the ALBUM/PRESET (10) or ALBUM/PRESET (11) button to select the album that you want to copy.
• Press the REC./DEL. button (18). "REC" will appear on the LCD display. Wait for a few seconds until the system
hasnishedreadingtheUSBmemorystickand"ONE"isdisplayed.
• Use the TUNING/SKIP wheel (8) to select "DIR", and then press the REC./DEL. button (18) again. The copy
process will start after a few seconds.
• Press the (9) or REC./DEL. button (18) to stop copying the album.
• "ENDREC“willbedisplayedwhentheleshavebeencopied.
10. Using the remote control
a) Inserting/changing the remote control battery
 Theremotecontrolbatteryisprotectedfromdischargebyanisolationlm.Removethislmbeforeuseby
pulling it out of the remote control's battery compartment.
• Change the battery when the turntable stops responding to the remote control (and you are sure that the infrared
sensor (17) is clean and that there are no obstacles impeding reception).
Follow the steps below to change the battery:
• Press the latch on the battery holder (see diagram on the remote control) and remove it from the back of the remote
control in the direction of the arrow.
• Remove the used battery (if applicable).
• Insert a 3 V CR2025 battery into the battery compartment. Ensure that you pay attention to the polarity markings
(plus/+ and minus/-). Refer to the diagram on the back of the remote control.
• Slide the battery holder back into the compartment in the opposite direction of the arrow.