Instructions

53
c) Inserting Batteries in the IR Remote Control, Battery Replacement
IfthereisathinprotectivelmontheIRremotecontrol,pullitoffnow.
The IR remote control needs a battery type "CR2025".
At initial commissioning, the battery is already in the battery compartment of the IR remote control. A plastic
strip protects the battery from premature discharge.
Pull out the plastic strip to make the IR remote control operational.
A battery change is required if the range of the IR remote control drops or the screen/DVR no longer reacts to the
IR remote control at all.
Toperformthebatterychange,thesmalllockingclipatthebatterycompartmentmustbeunlatched,e.g.withaat
screwdriver, upon which the battery holder and battery can be pulled out.
Replace the empty battery with a new one of type "CR2025". Always observe the correct polarity (plus/+ and
minus/-) when inserting the battery. The plus pole of the battery is marked with the icon "+" and must point towards
the bottom of the IR remote control.
Push the battery holder back into the IR remote control. Observe correct orientation. Do not apply any force!
Disposeoftheat,used-upbatteryinanenvironmentallycompatiblemanner;seechapter"Disposal".