Instructions
54
10. Basic Functions
a) Switching On/Off
Neither the screen/DVR nor the radio camera has an on/off switch. When the devices are supplied with power through
the respective mains adapter, they are ready.
Pushing the "
" button on the IR remote control permits activation and deactivation of the display at the screen/DVR.
The screen/DVR, however, continues to run internally.
b) Calling/Leaving OSD Menu
Brieypushthe"Menu"button(5)onthescreen/DVRorthe"MENU"buttonontheIRremotecontrol.Thenthemain
menu is displayed.
ToleavetheOSDmenu,brieypushtherespectivebuttonagain(severaltimesifrequired,ifthescreen/DVRisina
submenu).
c) Activating/Deactivating AV Output
Use the "TV OUT" button (10) on the screen/DVR or the "AV" button on the IR remote control to switch between
playback of the AV-signal on the screen/DVR and the AV-output.
If the AV-output is activated, the screen/DVR display goes out.
d) Setting the Volume
As a special feature, the small housing (21) in the radio camera's cable holds a microphone. The radio camera there-
fore not only shows the image of the monitored area, but also permits hearing monitored sound.
The playback volume at the screen/DVR can be set at the screen/DVR or via the IR remote control:
"
" button = increase volume
"
" button = reduce volume
At the bottom of the display, a bar chart with the currently set volume level appears when the button is pushed. This
display goes out again after a few seconds.
If the radio camera is operated too close to the screen/DVR (e.g. for testing at initial commissioning or
when logging the radio camera on to the screen/DVR), there may be a feedback and whistling sound. Then
reduce the volume.