User manual

ManualsBrandsRENKFORCE ManualsSurveillance CamerasDummy camera with solar panel

Installation

• First, choose a suitable mounting location for the dummy camera. The mounting location should

be in an area where the solar cell is exposed to the sun for a few hours during the day, otherwise

the rechargeable batteries cannot be recharged sufﬁ ciently.

• Mark the mounting position on the wall through the mounting holes of the wall bracket.

• Screw the dummy camera tightly to the wall. Depending on the wall, use screws and plugs that

are suitable for the surface.

Please ensure that no cables or wires are damaged when drilling/screwing the mount

into position.

• A rubber hose simulates the appearance of a connecting cable. Attach it to the corresponding

opening in the wall bracket (if required, clamp it between wall bracket and wall while screwing

the wall bracket to the wall).

• Adjust the alignment and inclination of the dummy camera as desired, so that it points at the

area to be monitored. Prior to the adjustment, unfasten the corresponding locating screw; do

not apply any force.

Operation

•

The integrated solar cell charges the two rechargeable batteries with sufﬁ cient solar irradiation.

• A red LED at the front of the camera ﬂ ashes when the rechargeable batteries are sufﬁ ciently

charged. This LED simulates an activated surveillance camera. If the rechargeable batteries are

not sufﬁ ciently charged, the ﬂ ashing of the LED is only very low, or the LED does not ﬂash at all.

Maintenance and cleaning

Maintenance or repairs may only be performed by qualiﬁ ed personnel or a specialist repair shop.

The product contains no parts that require servicing. Therefore, do not open/dismantle it.

Use a clean, dry, soft cloth for cleaning. Do not apply too much pressure on the housing, this could

result in scratch marks.

Never use abrasive cleaning agents, cleaning alcohol or other chemical solutions,

since these can damage the housing or even impair functionality.

Dust on the solar module reduces the charging current. For this purpose, you should clean the

surface of the solar module every now and then (approx. once a year).

Disposal

a) Product

Dispose of an unserviceable product in accordance with the relevant statutory regula-

tions.

Remove any rechargeable batteries inserted and dispose of them separately from the

product.

b) Batteries and rechargeable batteries

The end user is legally obliged (battery regulation) to return used batteries and rechargeable bat-

teries. Do not dispose of used batteries in the household waste!

Contaminated batteries/rechargeable batteries are labelled with these symbols to in-

dicate that disposal in the household waste is forbidden. The symbols for the relevant

heavy metals are: Cd=cadmium, Hg=mercury, Pb=lead (marking can be seen on the

battery/rechargeable battery, e.g. underneath the refuse bin symbol shown on the left).

You can return your used batteries/rechargeable batteries free of charge to the ofﬁ cial collection

points in your community, in our stores, or any place where batteries or rechargeable batteries

are sold!

You thereby fulﬁl your statutory obligations and contribute to the protection of the environment.

Technical Data

Operating voltage............................... 2.4 V/DC (2 NiMH rechargeable batteries of type AAA/Micro)

Dimensions.......................................... 155 x 83 x 200 mm (H x W x D with wall bracket)

Weight .................................................. 295 g (with wall bracket, without rechargeable batteries)

Operating instructions

Dummy camera with solar module

Item no. 754219

Intended use

The product looks deceptively similar to a functional surveillance camera and therefore, it can be

used for deterrence in secluded or critical areas (e.g. driveways, entrance areas etc.).

The dummy camera is intended for installation and operation in outdoor areas. The power is sup-

plied via rechargeable batteries (not included in the delivery, to be ordered separately) which are

recharged through an integrated solar module.

Always observe the safety instructions and all other information included in these operating in-

structions.

This product complies with the applicable national and European requirements. All names of com-

Package contents

• Dummy camera with wall bracket

• Operating Instructions

Safety instructions

The warranty will be void in the event of damage caused by failure to observe these

operating instructions! We do not assume any liability for any consequential damage!

TNor do we assume any liability for material and personal damage caused by improp-

er use or non-compliance with the safety instructions! In such cases, the warranty

will be null and void.

• The unauthorised conversion and/or modiﬁ cation of the product is not permitted for

safety and approval reasons (CE).

• The dummy camera is intended for installation and operation in outdoor areas.

• The product is not a toy and must be kept out of the reach of children. Install and use

the product where it is out of the reach of children.

• Do not operate the device in environments where there are high levels of dust, ﬂ

ammable gases, vapours or solvents. There is a danger of ﬁ re and explosion!

• Do not carelessly leave the packaging material lying around since this may become

a dangerous toy for children.

• Handle the product with care, it can be damaged by impacts, blows, or accidental

drops, even from a low height.

General notes about batteries

• Keep rechargeable batteries out of the reach of children.

• Do not leave the batteries lying around in the open; there is a risk of them being swallowed by

children or domestic animals. If swallowed, consult a doctor immediately.

• If your skin comes into contact with leaking or damaged batteries/rechargeable batteries, you

may suffer burns. For this reason, you should use suitable protective gloves.

• Batteries/rechargeable batteries must not be short-circuited, opened or thrown into a ﬁ re.

There is a risk of explosion!

• Do not recharge normal, non-rechargeable batteries, risk of explosion! Charge rechargeable

batteries intended for that use only.

• Only use rechargeable NiMH batteries for the dummy camera. Do not use normal batteries.

• Do not mix batteries with different charges (e.g. fully recharged and half-discharged recharge-

able batteries).

• Always replace the complete set of rechargeable batteries.

• Please pay attention to the correct polarity (plus/+ and minus/-) when inserting batteries.

Insert batteries

• Slightly turn the lid of the battery compartment on the rear in counter-clockwise direction, so

that it can be removed.

• Insert two NiMH rechargeable batteries of type AAA/Micro, with correct polarity (observe posi-

tive/+ and negative/-), into the battery compartment.

• Replace the battery compartment lid in the correct way and lock it by slightly turning it to the

right, in clockwise direction.

This is a publication by Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240 Hirschau (www.conrad.com).

All rights including translation reserved. Reproduction by any method, e.g. photocopy, microﬁlming, or the capture in electronic data

processing systems require the prior written approval by the editor. Reprinting, also in part, is prohibited. This publication represent

the technical status at the time of printing.