User manual

- 57 -
Conguring SATA Hard Drive(s)
C-1.UEFIRAIDConguration
ThismodesupportsWindows864-bitinstallationonly.
TocongureUEFIRAID,youneedtoprepareaUSBashdriveusingFAT32leformatandcopyallles
(includingtheUEFIRAIDutilityrcadm.e)inthe\BootDrv\UEFI RAID Utility folder in your motherboard driver
disktotheashdrive.Thenfollowthestepsbelow.
Step 1:
In BIOS Setup, go to BIOS Features and set OS Type to Windows 8 and CSM Support to Never.(Figure2)
Save the changes and exit BIOS Setup.
Running the UEFI RAID Utility
Restartyourcomputerandpress<F12>toenterthebootdevicecongurationmenu.Usetheupordownarrow
keytoselectyourUSBashdrivewhichisprexedwith"UEFI:"string.Thenpress<Enter>toaccessthescreen
as shown in Figure 3. To run the UEFI RAID utility, enter the following commands.
You can enter the commands at Shell or fsx:level(xrepresentsthedisknumberforyourUSBashdrive).
Figure 2
Figure 3
EFI Shell version 2.31 [4.653]
Current running mode 1.1.2
Device mapping table
fs0 : Removable HardDisk Alias hd15c0b blk0
PciRoot (0x0)/Pci (0x12, 0x2)/USB (0x2, 0x0)/HD (1.MBR,0xc3072e18, 0x1f80, 0xeea080)
blk0 : Removable CDRom Alias hd15c0b fs0
PciRoot (0x0)/Pci (0x12, 0x2)/USB (0x2, 0x0)/HD (1.MBR,0xc3072e18, 0x1f80, 0xeea080)
blk1 : BlockDevice - Alias (null)
PciRoot (0x0)/Pci (0x11, 0x0)/Unit (0x1)
blk2 : Removable BlockDevice - Alias (null)
PciRoot (0x0)/Pci (0x12, 0x2)/USB (0x2, 0x0)
Press ESC in 1 seconds to skip startup.nsh, any other key to continue.
Shell>