Operation Manual

17
„ACTION“
The„ACTION“commandspermitthefollowing:
SET =switchon/activate/congure
RESET =switchoff/deactivate/factorysettings
TEST =test/check/request
ENABLE =activatethealarmsystem(onlyforthefunction„ALARM“)
DISABLE =deactivatethealarmsystem(onlyforthefunction„ALARM“)
 Noteonthe„RESET“command:
 Ifafunctionistobeswitchedofforresetduetoanerror,thecorresponding„RESET“actionmustbeused
withthecorrespondingfunctionword!Thisactionisuniversallyapplicabletoallfunctions/textmessage
commands and resets the corresponding function to the default settings.
„FUNCTION“
Thisisusedtoselectthefunctionyouwanttochangeorperform:
TEL1 =phonebookentryno.1
NAME =NameoftheGX111
„PARAMETER“
Boththepresenceandthenumberofparametersdependonthefunctionandactionused.Therefore,most„RESET“
actionshavenoparameterswhile„SET“actionswithoutparametersare ratherrare(whatshouldbesettowhich
value).
A parameter may be the following:
List: Youmaychooseaparameterfromapre-denedlist.
 e.g.:DE,EN
 Writing:<DE/EN>
Number: An integer without decimal digits.
 e.g.:60=time[seconds](SETIDLEALARM60#1513)
More information:
• Capitalisationisnotrelevant;youmayusecapitalandsmalllettersasyouwish.
• Everynewcommandofthesamefunctionwilloverwritetheprevioussettings.
• Aftereveryvalidtextmessagecommand,theGX111willsendatextmessageanswertoconrmprogrammingto
your mobile phone (if the PIN in the text message command was correct).