User manual

b) General Conﬁguration Commands

This sub-chapter describes all general conﬁguration commands.

1. Changing the PIN Code („PIN“)

To secure the GX111 from unauthorised access, the standard PIN „1513“ may be set to any other value. The

PIN code can be changed as follows:

SET PIN <new PIN> #<old PIN>

Example: Changing old PIN 1513 to new PIN 1234:

SET PIN 1234 #1513

For every new text message command, the new PIN code now has to be appended (to stick with the ex-

ample: 1234), preceded by a crosshatch (#). If the wrong PIN code is entered or the PIN code is not sent,

you will not receive an answering text message. Changing of the PIN code will change both the settings of

the product and the PIN code of the micro SIM card! The PIN code always has 4 digits.

There is no „TEST“ action for testing this function.

If you lose the PIN code, the GX111 can be reset to factory settings (see chapter „Factory

Settings“). All settings will be lost when resetting! Then the device must be set again.

Resetting the GX111 to factory settings will not aect the micro SIM card. The PIN code of the

micro SIM card is not changed.

2. Changing the Device Name („NAME“)

If several GX111 are operated at the same time, it is recommended to assign a dierent name to each

GX111. This makes it easier to assign alarm messages to the correct device.

The device name has a maximum length of 20 characters.

To change the name at your GX111, send the following text message command:

SET NAME <new name> #1513

Example: Renaming to „NEWNAME“:

SET NAME NEWNAME #1513

You will receive the following conﬁrmation text message:

NEWNAME GX111 1.xx

To reset the device name to factory settings (no name), use the following command:

RESET NAME #1513